Kawasaki KLR Forum banner

Fork seal bushing question

2K views 1 reply 2 participants last post by  jerryv13 
#1 ·
Im changing out my fork seals.While flushing them out I turned them over and the copper/teflon bushing fell out .
Is this normal? All I need to do is slide it back in place correct?
thx
 
#2 ·
Hi Jeep, this this part come from the bottom part of the fork leg? looks like a flat washer? if it is, then yes, just put it back in, I suggest going to a parts website and looking at the schematic, this will tell you exactly where the part is supposed to go! I use bikebandit, but there are others
Good luck!

-Jerry
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top