Kawasaki KLR Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Other KLR's - 250, 600, Tengai, C Models, KLX...
    Hey everyone, I bought a keihin cvk34 carburetor off ebay for my 1997 klr250. The description said tested on a klr250 but I made the mistake of not inquiring about the year. The only difference that I see is a single throttle cable, no decelerate cable. Now I "think" it should work without two...
  2. New Member Introductions
    I just bought my klr 650 and It was pretty much love at first sight. Tengai aftermarket tank and many more extras including travel bags, lcd lights, 12 volt charging ports, phone holder, aftermarket exhaust... Etc. I'm having a blast but I think the next steps is replacing the windshield. It...
  3. 1987 through 2007 KLR650 Wrenching & Mods
    Good evening, I just bought a piece of the KLR 650 carburetor (Overflow pipe clamp, 92037-134), it is a piece with two rubber rings at its ends, one round (about 2 cm in diameter) and another oval (small) . I know it mounts on the bottom of the carb bowl, but I'm not sure how it mounts. Does...
  4. 2008 through 2018 KLR650 Wrenching & Mods
    First post so go easy on me ,please. My uncle passed away and I was gifted his 2009 KLR. Prior to his death, the bike had been sitting close to 4 years and of course would not start. I changed the oil, put a new air filter in, new battery, replaced the spark plug and emptied and cleaned out...
  5. 1987 through 2007 KLR650 Wrenching & Mods
    Hi, Engine on my KLR behaves strange now. My idle RPM is floating. I set it to 1300 as it's listed in manual, but quite often it goes to 2000 and then stuck there. Then it can go back randomly. This leads to overheat, backfire and unstable start - bike dies without a choke when it's cold and by...
1-5 of 5 Results
Top