Kawasaki KLR Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. 2022+ KLR650 Wrenching and Mods
    Hello Everyone, I have a 23 650 s non ABS with almost 10,000 miles. I'm asking to see if anyone's coolant reservoir looks like mine. I can't tell if the coolant is contaminated or the plastic housing is damaged. Please look at the pictures and tell me what you think. I'm located in southern...
  2. 2022+ KLR650 Wrenching and Mods
    I just installed a Thermobob 2a kit. Everything seemed to go according to plan, except the upper radiator hose is now contacting the engine. Note: This is the upper radiator hose, not the bypass hose. The thickness of the Thermobob housing pulls the hose to the throttle side of the bike just...
  3. KLR & Other Motorcycle Related Discussions
    My trustworthy little 250 keeps dumping coolant and draining out the radiator. The last ride I took truly became an adventure. It was upper 90’s when this happened but, I over heated, pulled over to let it cool and there was coolant draining out the reservoir drain tube, my reservoir full but...
  4. KLR & Other Motorcycle Related Discussions
    So I flushed and changed the coolant on my 2017 KLR. Everything seemed fine for a two rides. And then the morning after I noticed a small pool coolant under the radiator. It’s leaking from the lower corner fins only, with the gravity of the lean on the kickstand. The reserve tank hasn’t moved...
  5. 2008 through 2018 KLR650 Wrenching & Mods
    I have a 2012 KLR 650. I have been experiencing loss of coolant (no leaks) and an occasional foggy sit glass with the occasional hard starts and stinky exhaust indicating I have coolant making it’s way into the combustion chamber. That’s one problem. Then I lay it down gentle (5mph) and bent the...
  6. 1987 through 2007 KLR650 Wrenching & Mods
    Hello, I know someone will inevitably post a thread that already contains useful info, but I've done some serious searching as it is, yet the internet is a large place and I have specific questions. Onward. I have a 2007 KLR that runs hot, it is a newly acquired bike and sat for some time...
  7. 1987 through 2007 KLR650 Wrenching & Mods
    Hello, This is my first post on the forum so excuse my ignorance. I just replaced my clutch, and impeller and now when I try to replace my coolant it all drains out of the weep hole. The bike will run for about five minutes before the thermostat runs into the red. The radiator fan works but...
  8. 2008 through 2018 KLR650 Wrenching & Mods
    Hey Everyone, I picked up a 2009 KLR about two months back with 10k miles on it. Been parking it in my garage and noticed a VERY slow drip when I get back from riding on my garage floor. Once it dries, the place where the few droplets happened will turns white which makes me assume it's...
  9. 2008 through 2018 KLR650 Wrenching & Mods
    I have an 08 klr that I recently did the 685 big bore kit to, and I think I may have messed up the cam timings so I need to get in there and check them, do I have to drain the coolant or the oil for this? Pretty sure I don't have to do the oil but I could see the coolant being a problem. I can't...
1-9 of 9 Results
Top