Kawasaki KLR Forum banner

jetting

  1. Eagle Mikes Jetting- running rough down low?

    2008+ KLR650 Wrenching & Mod Questions
    Hi all. I have a 2009 with the airbox/snorkel mod and a Lexx MXE slip on with the "race" spark arrest or insert. I live at 700 feet above sea level. I just purchased an Eagle Mikes jet kit, and installed the KLX needle at 2nd clip from top (no spacers underneath). I drilled the slide, kept...
  2. Colorado Jetting

    2008+ KLR650 Wrenching & Mod Questions
    Hello, I live in golden colorado at 6000'. I am set up for supermoto/ mtn roads and canyons. 2008 klr 650 Two brothers valle pipe Airbox drilled Needle shimmed one washer Slide is drilled What jets should I use? How many turns out on air /fuel screw? I'm always down to ride if anyone is in...
  3. Need jetting advice

    2008+ KLR650 Wrenching & Mod Questions
    I had my local Kawasaki dealer install the stage two Jet Kit along with the Lexx MXe muffler. They had a lot of trouble getting it tuned right as the recommended set up per the instructions resulted in flattening out at 6500 rpm. They tried 4 or 5 settings before going back to the stock main jet...
  4. JD Jet kit installation- part one

    How To's & Tech Guides
    I was asked to re-post so that this guide could be stickied. Glad people found it helpful. I chose to go with a JD Jetting kit following excellent results on my dirt bikes. I realize that this flies in the face of cheapness, but I wanted to stick with what I knew. So, with some help from...
Top