Kawasaki KLR Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
New to the KLR world and tried a bit of searching but to no avail.

I am wanting to put risers on my 2022 Traveler. At what point am I going to have to have longer brake lines/clutch cable? Or will the 2in risers be fine.

Thanks!
 

·
Premium Member
Joined
·
9,214 Posts
Hopefully @2combs will be along to answer that question.
Usually some judicious re-routing of cables, wires or hoses has allowed enough.
 
  • Like
Reactions: Torquey

·
Administrator
Joined
·
4,017 Posts
I would contact Rox directly. The website shows that the risers work with stock cables for “All Years” of KLR.
 

·
Registered
Joined
·
14 Posts
Have the same plan for mine. However I hate those 33 inch wide bars. My plan is to slide the controls in an inch or more, whatever I can get. Cut the bar ends off and install the 1.5 inch risers. Figure the cables should be fine by shortening the bars. Haven't done it yet though.
 
1 - 4 of 4 Posts
Top