Kawasaki KLR Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
110 Posts
Discussion Starter #3
I see JNS has one for the '08's & newer. If the bolt pattern is the same as pre '08's, it might work.

http://jnsengineering.com/products-page/2008-2011-klr650/2008-2011-klr650-front-fender-brace/

Sleddog
At around $38.00 it would not hurt too much to give it a try, I could always drill it if the pattern is different. IIRC the Acerbis brace was twice as much.

I asked this same question at the "other" board, you would thought I was bring up an issue that was unheard of, the sail effect of the early model front fender at Hwy/Fwy speeds. I now remember why I quit going to the other board a few years ago.
 

·
Threadjacker
Joined
·
6,768 Posts
I think that one might be too long?...I looked for ya brother. Found nada
 

·
Registered
Joined
·
110 Posts
Discussion Starter #5
Thanks Lockjaw - I'll keep looking on ebay, classifieds, etc. Can't figure why this would be discontinued, well I know probably not a big money maker, but still a great product.
 
1 - 5 of 5 Posts
Top