Kawasaki KLR Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
I want to customize my blinkers. Anybody know if and where you can get hollow allthread the same as the plinker stalks. Thanks for any info.
 

·
Premium Member
Joined
·
1,429 Posts
I know you can get pipe nipples from a hardware store, I don't know if the threads will match up, but if your changing it you could just go with what they have, and change it all.
 

·
Registered
Joined
·
71 Posts
You can also buy longer/shorter turn signal stalks that might work with your stock housings. Dennis Kirk carries a large selection of different turn signal stalks.
 

·
Premium Member
Joined
·
4,751 Posts
All-thread's pretty soft, so it should be pretty easy to drill through a short length..
Usually, it's not heat treated and it's Grade 2 as far as hardness..
 

·
Registered
Joined
·
18 Posts
Discussion Starter #5
Drilling through 2 inches of all thread might be tough to do without screwing up the threads, and there is so little metal, wouldn't it get really hot??

I didn't find any just stalks at dennis kirk.

I'll check to see if a 1/4 inch nipple might fit.

Thanks for the suggestions
 

·
Registered
Joined
·
76 Posts
It's been a while but I found some at a local hardware store, not the big chain type. In the lighting department for rebuilding lamps.

TW
 
1 - 7 of 7 Posts
Top