[pdwestman]

IMS tanks are made out of polyethylene. Gen 1 plastics are all made out of polypropylene (if I am not mistaken. I would have to check the recycle code, but that's what I recall.). If I am mistaken on that, then they are made out of polyethylene, so macht nichts. Gen 2 fairings and tank shrouds (you know, the expensive shit that breaks easily) are made out of nice, brittle ABS.

Anyone know what the new Gen 3 plastics are made of yet?

 

[pdwestman]

Next objective is the CDT ride - should launch that next week.
Switched to the 16T counter-shaft sprocket as I need to ride 1160 mi to the starting point (Folsom CA to Antelope Wells NM). Then will put a new 15T on there.

At Oregon Buttes/Lander Cut-off road/South Pass (city? haha) area you will be with-in 42 miles of our shop. Lander Marine & Cycle, if needed.
That is going to be quite a ride.

Wishing you safe travels.

 

[pdwestman]

Looks like a Great route for a Sunday afternoon ride!

Did the bike pin your Right leg down for a bit, in that lay-down?

Looks like even the bicycles didn't agree with that powder bed very well!

 

[pdwestman]

Dang it, you missed me. Was probably running short on time due to those earlier road closures.
Ride Safe.