Kawasaki KLR Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
I read in the Clymer that there should be 1mm of the fork tube extending above the top clamp. Mine is flush with the top clamp so I guess I should fix this - need to adjust the head bearing anyway. Question is - to adjust the amount the fork extends, do I have to loosen both the upper and lower clamps at the same time? Did I do any damage by having the incorrect spacing (doubt it, but thought I would ask).

Thanks
 

·
Registered
Joined
·
650 Posts
Flush is good. or "just below the caps"

Nothing will be hurt by running them sticking up 3 inches either. there's no worry.
adjust the head bearing and your good to go.
 
1 - 2 of 2 Posts
Top