Kawasaki KLR Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
726 Posts
Are you 100% certain that the old washer & o-ring are extracted from the tower. If not then new assembly will not turn-in to fully closed position (coil-bound spring). I've built a tiny little 'fish-hook' out of a piece of mechanics wire to reach inside the towers.


I would has said that in reverse. starting with the needle. I put a little oil on the shank of the needle & its threads. Then install the spring on the needle, then the washer, then the o-ring. Install the Assembly into the tower.
Indeed, make absolutely sure the original o-ring has been removed before installing the new one.

Jason
 
1 - 1 of 1 Posts
Top