Kawasaki KLR Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi,

Can anyone measure and write JamesDean or DynoJet kit needle geometry/dimensions ??

I got an CVK40 for my DRZ. The carb is 2009. I think it has different needle than pre models (87-07), right ?? The newer should be leaner...

CVK40 is a very reasonable upgrade for DRZ, cost/perf. inc./fuel cons. are very nice. Most of the modifiers uses DNO228 needle (comes with DynoJet kit) and says better than oem cvk needle.

And I think also JamesDean kit needle(blue) is good.

I can make/produce needle so I only need dimension any of these two needle.
 
1 - 1 of 1 Posts
Top