Kawasaki KLR Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
12,006 Posts
Or install a Positive stud terminal into the 6" long black plastic panel near the fuel tap and an 8 gauge cable to either the input side of the starter relay or the positive battery terminal. Then jumper cables connect to the Positive stud and the nearby LH lower sub-fame bolt for Negative Ground.
Simple, Cheap & Easy.
 

·
Premium Member
Joined
·
12,006 Posts
A BAD battery will not recharge. And if you so much as touch the starter button when connected thru a Tender pig-tail it will fry its fuse instantly! A bigger fuse will cause the pig-tail wires to FRY!
The starter motor may pull 75-100 amps! That is why it needs 8 gauge Cables!
 
1 - 2 of 2 Posts
Top