Kawasaki KLR Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 2011 KLR650 that I got bored out to suit a 685 kit. After reassembly I have found that there is a pinhole in the sleeve allowing water to enter the cylinder. I have sourced a new sleeve but I am now chasing the 2x O-rings that go on the base of the sleeve in the cylinder.

Kawasaki doesn’t list this part as a spare part item after 2007 and use the excuse that these are throw away reboreable cylinders. I don’t believes that this is true because Schnitz offer an oversize sleeve that suits bikes 96 to current.

Has anyone replaced a cylinder sleeve on a bike from 2008 onwards and can advise if the 92005-1371 O-rings are compatible.
Thanks
Scott
 
1 - 1 of 1 Posts
Top