Kawasaki KLR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello, first post....hope it's ok...
I'm searching for the manual choke plunger set up that gets rid of the handle bar choke cable assembly that will fit a 2006 KLR.

I think I read a 1996 KLX250 set up will work....can anyone verify this to be correct?

Then if so, where's the best place to find this item which I bet is like chicken lips...lol
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
Thanks for the kawi number, they'll have one in a week or so.....cheaper than flea-bay if you add into their shipping costs etc etc.

Thanks again guys.
 

·
Registered
Joined
·
1,256 Posts
You can extend the push/pull knob out about four inches to make it easier to reach while sitting on the bike.

Remove the original knob.
Ziptie a piece of 1/4" flexible tube to the push/pull rod. I like Tygon fuel line from auto parts stores.
Put a piece of 5mm all thread rod in the line to stiffen it.
Make a new knob with some 5mm nuts and a washer.
Leave about 1/2" of the flexible tube next to the original rod open for flexibility so you can rotate the carb to work on it.
 
1 - 4 of 4 Posts
Top