Kawasaki KLR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
100 Posts
Discussion Starter #1 (Edited)
Just thought i would post some pics of my new TKPipe and stage 2 of my home made racks, the pipe sounds really deep and throaty i have put 3 washers under the needle, drilled 3 holes in the top of the airbox and dropped in a 155 main jet, goes very nicely now and looks beautiful and is about half the weight of the stocker
The racks are my second attempt as the first ones were made from solid round bar and would get the wobbles as speeds increased, the new ones are from tubing and dont require a rear stay ,so because they are seperate to each other one doesnt effect the other, once i get them right i am planning on selling them . Took the sidecover off for a better view, heres a short youtube vid of the pipe and below are some pics http://www.youtube.com/watch?v=ieAGHDrS_EU



 

·
Registered
Joined
·
100 Posts
Discussion Starter #3
I think so too, yes it is made in Australia by a bloke called Terry Kelly, it's a one man show and the quality is exceptional and quite a bit cheaper than Staintune
 
1 - 3 of 3 Posts
Top