Kawasaki KLR Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
hi, i just removed my sw-motech crash bars from my 16 klr 650,
i put the factory nuts/bolts back in & would like to tq them to spec. i couldnt find anything online for those specs.
 

·
Premium Member
Joined
·
6,822 Posts
OK, if I must!
8mm front engine mounts, 18 ft-lb.
10mm front engine mount, 32 ft-lb.
Upper sub-frame mount, 33 ft-lb.
 

·
Registered
Joined
·
135 Posts
OK, if I must!
8mm front engine mounts, 18 ft-lb.
10mm front engine mount, 32 ft-lb.
Upper sub-frame mount, 33 ft-lb.
Are these the bolt diameters for all the engine mounts? If not, does anyone happen to know what they are? :grin2:
 

·
Administrator
Joined
·
8,363 Posts
I think all the Gen 1 were the same, so for your '03:

Front:
(2) 8mm X 70mm
(1) 10mm X 75mm

Upper:
(3) 8mm X 42mm

Rear:
(1) 10mm X 145mm

On a Gen 2 the two front 8mm would be a bit longer to accommodate the ridiculous ears.
 
  • Like
Reactions: MTKKLR

·
Registered
Joined
·
135 Posts
I think all the Gen 1 were the same, so for your '03:

Front:
(2) 8mm X 70mm
(1) 10mm X 75mm

Upper:
(3) 8mm X 42mm

Rear:
(1) 10mm X 145mm

On a Gen 2 the two front 8mm would be a bit longer to accommodate the ridiculous ears.
Thank you thank you thank you.
 
1 - 6 of 6 Posts
Top