Kawasaki KLR Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi hope someone can help. I've just done up a 1994 klr 250, it's had a complete strip down, frame powder coated,rebuild with new nuts bolts. I've had it running but tick over was a little rough so I've re jetted the card now it wont even fire. Spark is good tried easy start tried fuel into the intake still not even a fast. Could it be the valves. Does anyone have any suggestions....please.
 

·
Administrator
Joined
·
4,017 Posts
Welcome to the forum. I would start with revisiting the carb. Something seems to have happened during the re-jetting process. Did you only change jets or a full carb rebuild?
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
Hi ,just changed all the jets and it a no go, then soaked all the old jets in carb cleaner blew them out with air and replaced and still nothing. I'm scratching my head can't figure it out.
 

·
Premium Member
2013 KLR 650/692, 2017 HD Electraglide Ultra
Joined
·
1,471 Posts
Check for spark. You may have knocked something loose whilst fiddling about under the tank. If you have spark, then you likely messed up something in the carb work. Also check your compression.
 
1 - 6 of 6 Posts
Top