Kawasaki KLR Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1


I turned up a punch to rivet the pipe to the backing plate in my axle press.



Tip all done and riveted together ready for mounting.



Drilled 4 equally spaced holes.



Spotted them through to the muffler, drilled and tapped.





Quick coat of paint and back together, all up around 4 hours work. Looks pretty good, if I do say so myself.

Most importantly though goes and sounds much better, well worth the effort. Just got to get some stainless socket head screws to finish it off nicely.

Cheers!



 

·
Registered
Joined
·
42 Posts
Discussion Starter #6
Cheers guys but seeing that I made it from bits and pieces of scrap found around the place it’s not really something that I intended to go “Commercial” with. If it gives you a few ideas to fab your own up, then my work is done!
 
1 - 6 of 6 Posts
Top