Kawasaki KLR Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1

·
Administrator
Joined
·
8,368 Posts
Thread size vs spanner size.

Tom
 

·
Registered
Joined
·
61 Posts
Discussion Starter #3
Thanks Tom,

So just to check i have got it, the nut size is based on the diameter of the hole in the middle of the nut and the spanner size is based upon the gap between the jaws (and hence the diameter from outside to opposite outside face of the nut/bolt)?
 

·
Administrator
Joined
·
8,368 Posts
  • Like
Reactions: Temporaryescapee

·
Registered
Joined
·
1,256 Posts
These nut and bolt size charts point out a aggravating point. When you replace an 8mm or larger JIS nut or bolt on the KLR with ANSI one from your local hardware store, The wrench size will be different and you will need to carry extra wrenches in your tool kit.
 
1 - 6 of 6 Posts
Top