Kawasaki KLR Forum banner

1 - 4 of 4 Posts

·
Administrator
Joined
·
3,563 Posts
Discussion Starter #1
Here's an alternative when doing the 22 cent mod. Install a thumb idle adjustment screw. Will allow you to fine tune the adjustment simply.

Found a good buy on an Idle Mixture Screw and they are including stainless allan head screws for the bowl. You could probably use them on the cap too. I hate those Phillips screws.

Shipping in USA is free until Nov. 7, 2010 so if you are thinking about it here's a good buy.

http://www.harley-performance.com/ez-just.html


Cool. I get to buy Harley parts for my bike.
 

·
Registered
Joined
·
327 Posts
Good deal! So all I have to do is pop the cap, unscrew the OEM Idle Mixture screw, then screw in this?

Go all the way in then pull out 1 and 3/4 turns?
 

·
Administrator
Joined
·
3,563 Posts
Discussion Starter #3 (Edited)
Ya if by pop the cap you mean drill out the plug.

Just be careful removing the screw from the carb because there is a spring, a washer and an o-ring on it. You don'want to loose that stuff.
 

·
Administrator
Joined
·
8,277 Posts
Red Burrito-

The taper on that needle is a bit different from the stock needle, but that's just about it.

Come out 2ish turns and fine tune from there to get the right mix at idle/small throttle opening.

Tom
 
1 - 4 of 4 Posts
Top