Kawasaki KLR Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
80 Posts
Removed the plastic hand guards ( bat wings ) on my 2015 model just because I think it looks better without them . Maybe some day I will but some metal bark busters on it . Maybe not .
 

·
Registered
Joined
·
80 Posts
raised my pre-load from 1 to 2 , made try at adjusting the dampening but need to do a better job of it , raised tire pressures to 26 front and 24 rear from service manual recommendation of 21 in both , cleaned and lubed chain , topped fuel ,checked oil level , and did some cleaning and polishing . Reay to go exploring some mt. backcountry I haven't seen except on a map in the morning .
 

·
Registered
Joined
·
80 Posts
Changed the windscreen mount on my gen 3. I put the top screw in the mount
, and set it on top of the bike side bracket, then put the lower screw through upper most screw hold in the bike side bracket. This raises the windscreen up 1 1/4" higher than the factory high setting, and adds some forward angle.

I also added some handlebar risers. Bike feels much better standing. I am 6' 1"

View attachment 32093 View attachment 32094 View attachment 32095 View attachment 32096
I like the ruger sticker . Looking for the right sticker for me in that location on my bike .
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top