Did not expect to see the Doohickey already done.

I use an electric engraver to write, "EM Doo & T spring DONE" on the beveled lower edge of the engine cover directly above the locking bolt for everyone in the future to READ on every KLR650 that I do the Doo on.
You might care enough to do the same.

 

Yeah im gonna engrave EM-DT. Was just irritating. Finished the water pump seal rebuild this morning, then decided to hit the doohickey task only to see its done once i pulled the rotor. They reused the original gaskets which led to a leak, so had to pull it all apart anyways. Was not as hard as i had imagined. But definitely a job that can go south easily.