I've googled and found something called Q bond that one video swore by. Is there anything store bought like Loctite or JB Weld plastic glue that is good? When I went down at 25 mph in the sand it popped the right tank fairing off the radiator. It was a smooth separation so now I need to glue the plastic pieces back to the fairing. I heard our fairings are made of polypropylene and not easy to glue. I think Loctite and JB weld have some good ones but if q bond is the way to go I'll order it on ebay. Thanks again for answering my million questions.
jeffrimerman
Jb weld for plastic. Scuff the surrounding area really well with 60-80 grit then wash the scuffed area with soap and water. Rinse very well then wipe the area with alcohol. Mix up the jb weld for plastic (2 part epoxy) and apply a nice thin layer brushing it around the scuffed area well. Worked on a gas tank I repaired very well
Sent from my LG-D850 using Tapatalk
Sent from my LG-D850 using Tapatalk
Get some fiberglass mesh tape about 2" wide. Apply the epoxy you are using to the area you scuff up on the back side. Then apply the mesh over the joint and then some more epoxy on top of the mesh. This adds lots of strength and has worked well for me.
Dryer sheet have been holding up pretty good
forum wont let me post the link, youtube: wanderingbeast motorcycle fairing fix
https://m.youtube.com/user/beast12101
Iv also had good luck melting zip ties as a plastic welding
forum wont let me post the link, youtube: wanderingbeast motorcycle fairing fix
https://m.youtube.com/user/beast12101
Iv also had good luck melting zip ties as a plastic welding
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
